TL-touch Auto Bed Leveling sensor high compatible heating bed sensor TL Touch leveling probe compatible FDM 3d printer
- Additional information
Name: TL-touch Auto Bed Leveling sensor
Compatible FDM 3d printer.(unavailable for Chitu)
-TL-touch is an auto leveling sensor for 3D Printers based on open-source.
-Simple, Smart, High-precision，It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.
Support , Marlin ,Repeiter ,Smoothieware,etc.
-TL-touch can be operated in the following condition.
-One I/O for control (PWM or Software PWM)
-One I/O for Zmin(Z Probe)
-GND and +5V power
2 *Dupont Housing Shell 3Pin
2 *Dupont Housing Shell 2Pin
1*10KΩ 1/8W Resistor for Smoothieboard
1* 240 KΩ 1/8W Resistor for 3.3V Logic Level
Additional power supply can be needed in case which your board does not supply enough amperage.
Electronic devices can be damaged or even destroyed if connected to the wrong side polarity. [wrong terminal connect to 5V(+) and GND(-)]
Install BLTouch as far as it possible from magnetic, motor, fan etc.
The action as pulling/pushing hard the push-pin can make the BLTouch damaged and less accurate.
Fix push-pin with locking paint after reassembling or adjusting core.
Please do not change the position of the hex screw(core).
Do not separate or deform elastic material attached on the push-pin.
The action(Pull or push push-pin hard) makes damage and lowers the accuracy of TL-touch.
Auto Bed Leveling sensor