mother board self balance Electric Scooter Parts Accessories Motherboard Control Board for Hoverboard 9 Items in Total
- Additional information
Wholesale 5 sets Scooter Control Board for Hoverboard/Electric 2 Wheel Scooter
– This buy link is for wholesale : (1 Motherboard, 2 Gyroscope boards, 2 Front LED lights boards, 2 Power Indicator boards, 1 Charger line and 1 Power cord) x 5 .
– NOT including a bluetooth board.
Controllers learning Calibration: off, long press the power button for 5 seconds, “drip” sound until around headlights flash, attitude data successfully saved, to be re-switch. (In the calibration, be sure to keep the left and right pedals parallel to the ground.)
Mode Switching: power-on default low sensitivity mode (beginner mode), the off state, press the power button, and within seconds the power button is pressed again, issued a drip sound mode is switched to the high-sensitivity mode (Motion mode). Reboot back to learning mode.
Tilt protection: stepping on the pedal, the pedal must be less than the level of 10 degrees beyond the angle, the motor stops, status indication red. Power indicator board each 6 LED. Cool side panel of each lamp 8 LED.
Uses: Suitable for assembling 2 wheel electric self balancing boards.
– (1 Motherboard, 2 Gyroscope boards, 2 Front LED lights boards, 2 Power Indicator boards, 1 Charger line and 1 Power cord) x 5 sets
– Packing size: 16 x 12 x 10 cm
Tips for repairing your scooter:
This post may help for all kind of (hover board) electric scooter fault diagnosis.
most of the faulty issues are because of some cables inside are loose or disconnect.
It usually caused from the shaking when shipping or riding or carelessness of our factory.
it will be easy to fix by yourself instead of wasting too much time for replacement.
the scooter has 3 circuit boards, one big main board and 2 co-board.
7 boards and 2 lines
For 6.5/8/10 inch 2 wheel selef balancing scooter(No Bluetooth)