Micromake 3D Printer Parts Makeboard Smart Controller 3D Printer Display 2004 Smart Controller Compatible with Ramps 1.4
- Additional information
Micromake Makeboard Smart Controller
Size: 15*6.3cm With PCB immersion gold process, the LCD Screen was rewired and optimized design based on Smart Controller. Exclusive use of high-grade oxide black aluminum alloy knob capwith non-plated plastic material. Screen printing pin definition of all interfaces on the back for convenient wiring and learning.
For hardware connection, please plug two 5*2pin USB cables into corresponding EXP1, EXP2 interface of control board respectively. For firmware configuration, you need to take following measure to modify one code according to your firmware type (Marlin or Repetier). If you use Marlin firmware, please open Configuration.h file and press Ctrl+F to search REPRAP_DISCOUNT_SMART_CONTROLLER Delete “//” in front of the line, then you can unlock the LCD screen functions of firmware. The code as follows:
If you use Repetier firmware, please open Configuration.h file and press Ctrl+F to search FEATURE_CONTROLLER Change FEATURE_CONTROLLER into 2, then you can unlock the LCD screen functions of firmware. The code as follows:
We will test the LCD Screen before shipment, it wouldn’t be sent out unless we ensure it can work normally. If the LCD Screen doesn’t light after turning on the power, please check whether the wires of EXP1, EXP2 interface are plugged opposite or not. If it’s light but doesn’t display words or full of squares, please adjust the adjustable resistor CONTRAST back of screen. If what you use is not Makeboard control board, maybe the direction of socket is opposite, please change another direction to plug.
3d printer parts